Accelerator Pedal Throttle Kit Right Hand Drive
Type 2 Kombi 1967-1969 Early Bay Window
This part of the kit is the main wear area on 1967-1969 buses
The kit mounts to the throttle pedal then goes down through the cab floor to the main swivel section. These kits have sealed roller bearings that allow everything to rotate nice and smoothly. Kit also has a double ended rose joint rod that if you feel needs adjusting you can.
The kit has recently been uprated with a NEW stainless steel top hat section (That`s the part that is usually welded to your floor that the kit bolts to ) These come as standard with every kit , you will need to remove the original steel mount then bolt this stainless mount up in its place . Comes with 4 stainless steel bolts nuts and washers .(Just make sure when bolting up , the push rod from the pedal is centred in the hole in the floor) it will be if the plate is centred over the large hole .
Also these joints are encased inside a rubber boot to keep all the crud and dirt out as your front wheel is situated right behind the joint.
Plus there is now a tiny 8mm spanner included in the kit, to be used when fitting the small balljoint to the throttle pedal (doesn’t seem much but an absolute time saver, believe us).